How to connect a Windows computer to a wireless network using a Canon mg2922 setup that is Wi-Fi protected. Make sure your printer is powered on and plugged in before you start. In front of it will be a light-up button. While the printer is turned on, press and hold the Wi-Fi button until the amber alert light flashes.
Release your grip on the Wi-Fi button when it flashes, then check to see if the power and Wi-Fi lights are both on and rapidly flashing. While the Wi-Fi light is blinking, press and hold the WPS button on your wireless network or access point. You might see a button similar to this one depending on your router. When the Wi-Fi light starts to flash, you have two minutes to finish this step. When the Wi-Fi and on lights both stop flickering and stabilise, the printer and wireless router are connected.
How to install and setup a Canon Mg2922 Wireless
After turning on your computer, insert the CD ROM that came with Canon Pixma mg2922 Troubleshooting to configure your printer and install drivers. Download the installation files from the Canon website. Click on these links to download the printer's software and configure WiFi on the Canon Mg 2922.
Start by opening the downloaded file on your computer and going through the welcome screen's instructions. After choosing wireless land connection as your connection type, click Next to select access point connection. When you click Next, the software will check to see if your printer is already turned on and logged into the network. If this is your first time installing the printer, the list should be blank. There was no checkbox where you could select the printer on the list. Click Next if the printer is already listed. The installation of the wireless printer will then begin after selecting Next on the following two windows. This or this may appear on your screen after you've clicked the WPS button. Click Next to find your printer on the network. Select your printer and click Next when you see the window indicating that the connection was successful. Pick a software from the list that displays to view the License Agreement screen. Select yes to continue with the installation. At this point, the software installation will be completed by clicking Next.
How to setup the Canon Mg2922 for a wireless network
The Canon Mg2922's technical handbook may take some time to WiFi-enable. Click Next when the dialogue box stating that the Canon mg2922 configuration is finished appears. After choosing complete, the printhead alignment screen appears. Select the execute button on the screen. Start the printhead's alignment. Any instructions shown on the screen must be complied with. To exit the software after the printhead alignment is finished, click Next.
build a printer At this time, you will be prompted to register your product. If you want to register right away, a new window will open after registration is complete. It is now mandatory to install the enlarged survey application. The extended survey programme won't be installed immediately away if you decide not to. Put some plain paper in the printer to open the test print window, then select "Agree" to print a test page. Click execute after printing a test page. You can also omit the test printing by choosing next. When you see this screen, click Exit to complete the installation. With WPS enabled on a Windows computer, the Canon Pixma mg 2922 can now be fully configured to a wireless network and used to print or scan.
References: Canon Pixma mg2922 Setup